Introduction to the common problems of the jet mill

Weather flow crusher manufacturers to introduce some common problems of airflow crusher, I hope to help you, let's learn about it.

1. What materials can be used for the grading wheel of the jet mill? And what is the main reason for the lining of the grinding chamber?

The grading wheel of the jet mill can be made of carbon steel, ceramics, etc. Which one is used in detail depends on what materials the mill is crushing and grading, which is decided by it. As for the lining of the mold cavity of the jet mill, it mainly depends on the type and nature of the material. For different situations, the appropriate type should be selected so that it can have a good use effect.

2. Is the airflow crusher used in the laboratory of the pharmaceutical industry as small as possible? And, will the feeding speed of the airflow crusher affect the particle size of the material?

The airflow crusher used in laboratories in the pharmaceutical industry is as small as possible, so on topic one, the answer is yes, that is, the answer is yes. Because this can reduce the loss of the crusher, and only need to play the experimental purpose. The feed rate of the jet mill will not affect the particle size of the material, so on the second topic, the answer is negative.

3. Which one has a slightly wider application surface, airflow crusher or screen crusher?

On this topic, if, from a professional point of view, and compare, then, is the latter, that is, the screen crusher, the application of this kind of crusher, to be slightly wider. Because the jet mill is to crush the material with a particle diameter of less than 5mm, its material requirements are relatively high, and it is mainly used to crush the material that has been preliminarily crushed again. That is why we have come to this conclusion.